This is a single phase SCR power regulators and temperature controllers 2 in 1 units, in a typical heating system, you would need a temperature controller and a SCR power regulators, and they are two separate devices, we go further and build this two devices in one package, this saves a lot of efforts for panel builders when it comes down to wiring, and RS-485 modbus is a standard feature, controller can be integrated to systems with HMI or PLC etc. the load can be directed wired to this thyristor power regulators, and it works with all kinds of inputs, Thermocuple, RTD, analog signal

Maxwell DR04C is a din rail mount PID temperature controller, 2 channel configuraitons, works with TC/RTD inputs, and output can be Relay, SSR Drive, or analog like 4-20mA, 0-10VDC, 2 auxiliary outputs can be assigned as the alarm output for any of the channel, or it can also be configured as the cooling output, in some particular application, the auxiliary output can also be programmed as an event output which is controlled by a master device via RS-485 communication, the RS-485 is a standard features. 24VDC source to sure greater saftey.

IoT is getting more and more popular, to keep up with the trend, for some of temperature control system with PLC in it, we offer an alternative solution by using our DIN rail temperature controller plus our IoT box, or IoT HMI, the concept is implementing DIN rail temperature controller system and connect it with IoT HMI plus various I/O modulars, so that the PLC can be eliminated from the system, 

Maxwell DR04D is a din rail mount PID temperature controller, 4 channel configuraitons, support thermocouple inputs(K,E,J,N,W,S,T,R,B), and output can be Relay, SSR Drive, or analog like 4-20mA, 0-10VDC, PID or ON/OFF control mode, RS-485 modbus communication as standard features, 24VDC source for greater saftey, auto/manual control switchable, when you have a sensor failure, the system can be quickly switched to manual control mode to maintain the temperature, soft-start and run/stop features.

Maxwell DR02B is a din rail mount PID temperature controller, 2 channel configuraitons, support thermocouple inputs(K,E,J,N,W,S,T,R,B), and output can be Relay, SSR Drive, it's a very simple din rail mount ccontroller, PID or ON/OFF control mode, RS-485 modbus communication as standard features, 85~265Vac source for easy system intergration, auto-tuning for both loops and with an external plug and play external configruation devices. the field configuration will be very easy to carry out.