3 digits display LED display programmable timer

● Digital programmable timer● 48mm*48mm, LCD display,6 digits● Display format,00.00.00, seconds,minutes,hours● Panel mount type● Dry contact, NPN input● Maximum 4 outputs(Relay or SSR Drive)● 85~265Vac or 24VDC source

● Digital programmable timer+counter,● 48mm*48mm,Dual line 4 digits display● 2 in1 timer+counter● Various timer triggering mode● OP1 output for timer and OP2 output for counter● 85~265Vac or 24VDC source● Perfect solution for application need timer and counter

● Digital programmable counter● 48mm*48mm,Dual line 4 digits display● Panel mount type● Dry contact, NPN input● Maximum 2 outputs(OP1 and OP2)● 85~265Vac or 24VDC source● SV counting/Batch counting/Totalizing count

● Digital programmable counter● Dual line 6 digits LCD display● Panel mount type● Dry contact, NPN input● Maximum 4 outputs(OP1 and OP2)● 85~265Vac or 24VDC source● SV counting/Batch counting/Totalizing count

Maxwell DR04E is a din rail mount 4 input 4 relay outputs I/O modules, input can be dry contact or NPN input, 4 relay output can be controlled from master device like HMI or PLC, the input work independently apart from output, or the input can be programmed to work correlated with the output. 8 channel of timer incorporated.

The NTC10K Series is a compact, high-precision Negative Temperature Coefficient (NTC) thermistor temperature sensor housed in a rugged stainless steel M8 screw-body probe. Designed for direct installation into threaded ports on pipework, tanks, heat exchangers, and machinery, this sensor delivers accurate, low-cost temperature measurement across a wide operating range without the need for signal conditioning or cold-junction compensation.At the heart of the sensor is a precision NTC thermistor element with a nominal resistance of 10 kΩ at 25 °C and a B-value (B25/100) of 3950 K ± 1%. The thermistor element is encapsulated within a 4 mm diameter stainless steel probe, sealed with high-temperature epoxy resin to ensure moisture ingress protection. The M8 threaded body incorporates a high-temperature silicone gasket to provide a leak-proof seal when installed into a threaded port. A 150 mm flat silicone lead wire terminates in a standard 2-pin SMP (Micro-Fit style) connector for fast, tool-free connection to the host system.The NTC10K series is fully compatible with Maxwell's range of temperature controllers, as well as third-party controllers, HVAC control boards, and microcontroller-based systems that accept a passive NTC thermistor input. The sensor's small probe diameter, short lead wire, and plug-and-play connector make it an ideal drop-in component for OEM equipment manufacturers and system integrators.

- head mount Modbus RS-485 temperature transmitter- TC/RTD inputs- 12-35V DC source- Modbus RTD RS-485 communication- Electrical isolation between input/output and source- PA66 housing  

● MW-DT-50● Size:50mm*100mm*96mm● Heatsink for 60A SSR● Panel mount and Din rail mount with clamps● Aluminum heatsink● For single phase SSR