LCD display programmable timer

● Digital programmable timer● 48mm*48mm,72mm*72mm,96mm*96mm● Panel mount type● Dry contact, NPN input● Maximum 4 outputs(Relay or SSR Drive)● 85~265Vac or 24VDC source● Perfect for Ozone generators, can control up to several loads

● Digital programmable timer+counter,● 48mm*48mm,Dual line 4 digits display● 2 in1 timer+counter● Various timer triggering mode● OP1 output for timer and OP2 output for counter● 85~265Vac or 24VDC source● Perfect solution for application need timer and counter

● Digital programmable counter● 48mm*48mm,Dual line 4 digits display● Panel mount type● Dry contact, NPN input● Maximum 2 outputs(OP1 and OP2)● 85~265Vac or 24VDC source● SV counting/Batch counting/Totalizing count

● Digital programmable counter● Dual line 6 digits LCD display● Panel mount type● Dry contact, NPN input● Maximum 4 outputs(OP1 and OP2)● 85~265Vac or 24VDC source● SV counting/Batch counting/Totalizing count

- head mount Modbus RS-485 temperature transmitter- TC/RTD inputs- 12-35V DC source- Modbus RTD RS-485 communication- Electrical isolation between input/output and source- PA66 housing  

● MW-W-70● Heatsink for 40A SSR● Panel mount only● Aluminum heatsink● For single phase SSR

The PT100-14 is a bolt-on PT100 Platinum Resistance Thermometer designed for direct surface temperature measurement. The sensor element is integrated into a ring (eye) terminal lug that is bolted or screwed directly onto the surface to be measured — such as a motor casing, heat sink, pipe outer wall, bearing housing, or structural component — ensuring intimate thermal contact without the need for a thermowell, probe pocket, or adhesive. This makes the PT100-14 an exceptionally convenient and cost-effective solution wherever surface temperature monitoring is required. The ring terminal inner diameter is available in 6 mm or 8 mm as standard, and can be customised to match any bolt or screw size specified by the customer. The sensor is supplied with a stainless steel braided cable for mechanical protection and EMI shielding, and the lead wire material is fully selectable from stainless steel braid, silicone, fiberglass, or Teflon to suit the thermal and chemical conditions of the installation environment. Standard cable lengths are 2 m, 3 m, and 5 m, with custom lengths available on request. The sensor is available in temperature ranges up to 100 °C, 200 °C, or 300 °C.

● Three phase solid state relay● 5-32Vdc input● 24~480Vac load● only available with 10/25/40 amps● Zero-crossing trigger● For resistive load only