FAQ
Home /FAQ /

The SCR power controller does not deliver any output. What should I check?

The SCR power controller does not deliver any output. What should I check? Jul 24
  1. Verify that the mains voltage is present on all phases.
  2. Check the semiconductor fuse(s) – an open fuse will block output.
  3. Confirm the setpoint signal (4–20 mA or voltage) is present and within range.
  4. Check that the Enable / Run input is active (usually a dry contact closure).
  5. Look for any alarm states (over-temperature, phase loss) that might inhibit firing.
  6. Ensure the correct firing mode is selected (e.g., zero-cross for resistive, phase-angle for transformer loads).

Maxwell is your best solution for thermal process and industrial automation application
24-hour after-sales service hotline : +86-592-6382791
Social Contact

Scan via wechat

Scan to Whatsapp

© 2026 Xiamen Maxwell Automation Limited All Rights Reserved | Sitemap | Xml | Privacy Policy |
IPv6 network supported

Leave A Message

Leave A Message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

Home

Products

contact

whatsapp